e-Support Filename:
TP10 123b.pdf
Date:
06-19-13
Page 8 of 15
IF A MACHINE HAS THE NEWER TYPE HOPPER INSTALLED, ENSURE THAT
THE NEWER TYPE STEPPED SCREW FS2-9012-000 IS INSTALLED
IN “POSITION 1”, AS INDICATED IN PAGE 5 AS WELL AS ON
STEP 2 ON PAGE 7.
FS5-9216-020 MUST BE USED WITH OLDER STYLE HOPPER IN POSITION 1
FS2-9012-000 MUST BE USED WITH NEWER STYLE HOPPER IN POSITION 1
THESE TWO SCREWS ARE NOT INTERCHANGEABLE.
The shape of the positioning hole on the plate of the Black Hopper Assembly (FM3-4715) has been modified.
The Black Hopper “Positioning Hole”
on the left side of the assembly
was changed to a
horizontally
elongated hole
to prevent abnormal stress from being applied to the Black Hopper. The Black Hopper
alignment is enhanced by using
one Stepped Screw only
on the left side of the assembly, as shown above.
Service Work:
If E025-0402 occurs, or if replacing the Black Hopper Assembly (FM3-4715) due to some other reason,
please, perform the following operation. Servicing work for both, older style Hopper and newer style Hopper
is described below.
(Step 1)
Actions Common to Both Newer and Older Style Black Hoppers:
A.
Check to see that the tie-wraps for cable routing are not pinching the wires in the black hopper
assembly. Check if the tie-wrap around the yellow cable has been tucked into the gap between the
Toner Supply Pipe and plate of Developing Drive.
If the wire does not move, it may be pinched.
Area below the Hopper
