Canon imageRUNNER ADVANCE C2020, Service Handbook

Page: 71 / 292

CHAPTER 2 STANDARDS AND ADJUSTMENTS
2-11P
3.2 Executing Paper Width Reference Point Auto Adjustment
for the Manual Feed Tray
FUNCTION>CST>MF-xx (xx=A4R, A6R, A4)
<Making Adjustments>
1) Place A4R paper on the manual feed tray, and adjust the slide guide to the paper width.
2) Start service mode, and make the following selections: FUNCTION>CST>MF-A4R (to
highlight); then, press the OK key.
3) For A6R and A4, perform the same to register the appropriate reference points,
REF.
To make fine adjustments after auto adjustment, use the following:
ADJUST>CST-ADJ>MF-xx (xx=A4R, A6R, A4).
3.3 Adjusting the Paper Width Basic Value for the Manual Feed
Tray
ADJUST>CST-ADJ>MF-xx (xx=A4R, A6R, A4)
Perform the following if fine adjustment is needed after “3.2 Executing Paper Width Ref-
erence Point Auto Adjustment for the Manual Feed Tray.”
<Making Adjustments>
1) Start service mode, and make the following selections: ADJUST>CST-ADJ>MF-A4R
(to highlight).
2) Enter the appropriate value using the keypad, and press the OK key.
3) For A6R and A4, perform the same to make fine adjustments.