Canon imageRUNNER 6570, Network Manual

Page: 53 / 274

Protocol Settings 3-7
3
Using a TCP/IP
N
e
tw
or
k
●
Using RARP:
❑
Press [RARP].
❑
Enter the IP address, subnet mask, and gateway address.
If this information cannot be obtained via RARP after you restart the machine,
the settings entered in this step are used.
●
Using BOOTP:
❑
Press [BOOTP].
❑
Enter the IP address, subnet mask, and gateway address.
If this information cannot be obtained via BOOTP after you restart the
machine, the settings entered in this step are used.
NOTE
•
Only one of the DHCP, BOOTP, or RARP settings can be selected at any one time.
•
Even if you press [DHCP], [BOOTP], or [RARP], you should enter an IP address,
subnet mask, and gateway address. If this information cannot be obtained from the
DHCP, BOOTP, or RARP server, the settings entered in this step are used.
•
If the machine is restarted after DHCP, BOOTP, or RARP settings are complete, the
TCP/IP Settings screen displays the IP address setting values obtained from the
DHCP, BOOTP, or RARP server. (If the IP address, host name, and domain name
have been previously set, these will be overwritten by the setting values obtained
from DHCP, BOOTP, or RARP.)
•
If you use DHCP without the DNS dynamic update function, it is recommended that
an identical IP address be assigned to the machine at all times. (If the IP address is
not identical, the host name for the machine will not correspond to the IP address.)
•
It takes about two minutes to check whether the DHCP, BOOTP, or RARP settings
can be used. If you do not plan to use one of these settings, it is recommended that
you turn them off.
7
Confirm the settings you specified
➞
press [OK].
The display returns to the TCP/IP Settings screen.