Canon ImageRunner 2030i, Reference Manual, Page: 110 / 412

Finisher-U2 3-11
3
O
p
ti
on
al Equi
pm
ent
CAUTION
Do not place your hand in the roller or the part of the tray where stapling is
performed if the finisher is attached, as this may result in personal injury.
IMPORTANT
•
If the Staple mode is set, the output trays move downward as the stack of paper that is
output increases in quantity and thickness. Once an output tray has reached its stacking
limit, printing and stapling stop temporarily. Remove all of the stapled prints from the
output trays, and printing and stapling resume.
•
Only the following paper sizes can be stapled: 11" x 17", LGL, LTR, or LTRR.
•
You cannot staple envelopes, transparencies, or labels.
•
Do not pull copies or prints out of the output area while they are being stapled. Remove
the copies or prints after they are output to one of the output trays.
NOTE
•
The maximum number of sheets, including cover sheets, that can be stapled together is
as follows (only 17 to 22 lb bond (64 to 80 g/m
2
) paper can be used for the main
document, and 17 to 32 lb bond (64 to 128 g/m 2 ) paper can be used for the cover page):
- LTR
50 sheets (17 to 22 lb bond (64 to 80 g/m
2
))
- 11" x 17", LGL, LTRR
30 sheets (17 to 22 lb bond (64 to 80 g/m
2
))
•
If the machine stops while stapling and the message <Load staples.> appears, almost all
of the staples have been used, and the staple cartridge must be replaced. To proceed,
replace the staple cartridge. (See “Replacing the Staple Cartridge,” on p. 7-15.)