Canon imagePROGRAF iPF820, User Manual, Page: 77 / 702

Control Panel
System Setup
Setting Item Description, Instructions
Buzzer Set the buzzer. Choose On for the buzzer to sound once for
warnings and three times for errors.
Warning
Detect Mismatch Choose Warning for notication (display of a warning message)
during printing if the type of paper specied in the printer menu
does not match the type in the printer driver. Choose
None to
continue to print without notication. Choose Pause to have
printing paused under these circumstances. In this case, you
can continue printing by pressing the
Online button.
Keep Paper Size Choose On to use the paper size setting as the basis for printing
instead of other settings. The margin setting of the printer menu
will be used instead of the margin setting of the printer driver if
the latter is smaller, which may prevent text or images in the
margin from being printed.
Choose Off to use the printer driver settings instead. Even if the
margin setting of the printer driver is smaller than that of the
printer menu, text or images will not be cut off. However, this
requires longer paper because the actual margin will be equal to
the margin setting of the printer driver plus the margin setting of
the printer menu.
Sht Selection 1 If sheet size detection is activated, choose whether ISO A3+
or 13"x19"(Super B) is applied when an intermediate size is
detected.
Paper Size Basis
Sht Selection 2 If sheet size detection is activated, choose whether ISO B1
or 28"x40" (ANSI F) is applied when an intermediate size is
detected.
Use Optimal Size Selects the optimal paper size to minimize the amount of paper
wasted. Roll Switching
No RollSwitching Prints using the roll currently advanced on the Platen.
TrimEdge Reload Specify whether to trim the leading edge of the currently
retracted roll when the roll is advanced. Cut the edge if you are
concerned about any marks left on the roll when the roll is left
in the retracted position. Selecting
On will always trim the edge
when the roll is advanced from the retracted position. Selecting
Automatic will trim the edge when the roll has been in the
retracted position for two days or more.
Printer Parts 63