Canon ImageCLASS MF4690, Service Manual

Page: 150 / 182

Chapter 14
14-10
14.3.7 SSSW-SW13
14.3.7.1 List of Functions
0016-2017
T-14-9
14.3.7.2 Detailed Discussions of Bit 2
0016-2018
It converts "inch" into "mm" when transmitting the received image data.
Scanning direction in conversion follows the Bit 2 setting of SW14.
14.3.8 SSSW-SW14
14.3.8.1 List of Functions
0016-2019
T-14-10
14.3.8.2 Detailed Discussions of Bit 2
0016-2020
Use it to specify whether to convert or not convert an inch-configuration resolution into a millimeter-configuration resolution for image read in G3 transmission:
either in sub scanning direction only or in both main and sub scanning directions. The setting is valid only when bit 1 of SW05 of #SSSW is set to '1'.
14.3.8.3 Detailed Discussions of Bit 4
0016-2021
Use it to specify whether to declare or not declare an inch-configuration resolution to the other machine for G3 communication: if 'declare' is selected, the machine
will indicate that it reads and records at an inch-configuration resolution using the DIS, DCS, or DTC signal.
14.3.9 SSSW-SW18
14.3.9.1 List of Functions
0016-2022
T-14-11
32 min 1 * 1 0 * * * *
64 min 1 * 1 1 * * * *
Bit Function 1 0
0 not used - -
1 not used - -
2 Convert "inch" into "mm" when transmitting the received
image data convert do not convert
3 not used - -
4 not used - -
5 not used - -
6 not used - -
7 not used - -
Bit Function 1 0
0 not used - -
1 not used - -
2 direction of scanning for inch/mm conversion both main and sub
scanning directions sub scanning
direction only
3 not used - -
4 inch-configuration resolution declaration declare do not declare
5 not used - -
6 not used - -
7 not used - -
Bit Function 1 0
0 Detection of carrier disconnection between the DCS
signal and the TCF signal Yes No*
Time-Out Length for
Reception Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0