COPYRIGHT © 1996 CANON INC. CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
5–42
5. INSTALLATION
11-5)Check to make sure that the notation of the
Keypad-A1 is as follows, and disconnect the
Keypad-A1.
Figure 5-520
12) Attach the switch settings label to the upper
cover 5; then, record the setting of each
switch on the label.
Figure 5-521
13) Fix the upper cover in place using two screws
7.
When doing so, make sure that the cable of
the power supply unit is held in position on the
cable guide inside the unit, and it is not
trapped by the upper cover.
14) To connect the Control Card Printer A-1, con-
nect it to the connector (J4) of the Copy Data
Controller-A1. (As necessary, use a relay
cable.)
Figure 5-522
15) If the entire length of the cable is inside the
Copy Data Controller-A1, end the work.
Attach the petty-pull 8 on the right bottom of
the copier's rear.
Figure 5-523
16) Fix the cable connected to the Copy Data
Controller-A1 to the petty-pull.
17) Check to make sure that the cable is not
trapped by the casters of the copier or the
sorter.
8
J4
5
6
7
7