Canon D1100 Series, Service Manual

Page: 124 / 227

4
4
4-67
4-67
Disassembly/Assembly > Controller System > Removing the Engine Controller Unit (TYPE II) > Procedure
Disassembly/Assembly > Controller System > Removing the Engine Controller Unit (TYPE II) > Procedure
10) While Pulling Out the Flat Cable [1] and the Harness [2] from the Hole Of the Host
Machine, Remove the Engine Controller Unit [3].
[3]
[1]
[2]
11) Remove the Engine Controller PCB [1].
4 Screws [2]
[1]
[2]
[2]
x4
•
F-4-148
F-4-149
Removing the Engine Controller Unit (TYPE II)
Preparations
1) Removing the Right Cover.(Refer to page 4-23)
2) Removing the Left Cover.
(Refer to page 4-19)
3) Removing the Left Rear Cover.
(Refer to page 4-22)
4) Removing the Controller Cover.(Refer to page 4-55)
5) Removing the NCU PCB.
(Refer to page 4-58)
6) Removing the ADF/Reader Driver PCB.(Refer to page 4-55)
7) Removing the Main Controller Board.(Refer to page 4-56)
8) Removing the Controller Box.(Refer to page 4-62)
9) Removing the Rear Cover Unit.
(Refer to page 4-27)
Procedure
1) Remove the Duplex Reverse Sensor Unit [1].
1 Connector [2]
1 Cable Clip [3]
1 Guide [4]
1 Screw [5]
[1]
[3]
[5] [4]
[2]
x2
■
■
•
•
•
•
F-4-150