Canon Color imageRUNNER C4580, Service Manual

Page: 724 / 851

Chapter 19
19-79
ORG-LGL Used to set special paper size not compatible with DF size recognition.
0: LEGAL [Factory default/After RAM clear]
1: G-LEGAL
2: FOOLSCAP
3: A-FOOLSCAP
4: FORIO
5: OFFICIO
6: E-OFFICIO
7: A-OFFICIO
8: M-OFFICIO
9: B-OFFICIO
2
ORG-LTR Used to set special paper size not compatible with DF size recognition.
0: LTR [Factory default/After RAM clear]
1: G-LTR
2: A-LTR
3: EXECTIVE
2
ORG-B5 Sets special paper sizes that cannot be detected in ADF.
Setting values
0: B5
1: K-LEGAL
[Factory settings and after RAM clear: 0]
2
UI-COPY Use it to select whether to display the copy screen in the control panel.
Setting value
0: Do not display the copy screen.
1: Display the copy screen.
[Factory default/After RAM clear: 1]
2
UI-BOX Used to select whether to display operation panel box screen.
0: Don't display
1: Display [Factory default/After RAM clear]
2
UI-SEND Used to select whether to display operation panel send screen.
0: Don't display
1: Display [Factory default/After RAM clear]
2
UI-FAX Used to select whether to display operation panel fax screen.
0: Don't display
1: Display [Factory default/After RAM clear]
2
C4HTR-DT Cassette heater: Sets lighting ratio of cassette on 4th level.
Whenever possible, avoid using this setting during normal operation.
2
C2HTR-DT Cassette heater: Sets lighting ratio of cassette on 2nd level.
Whenever possible, avoid using this setting during normal operation.
2
Y-PTN Used to eliminate 100 mm horizontal lines.
0: Don't imprint Y dot patterns on intermediate transfer belt.
1: Imprint Y dot patterns on intermediate transfer belt (only when reading color documents; Factory
default/After RAM clear).
2: Imprint more Y dot patterns on intermediate transfer belt than when value of 1 is set.
K dot patterns are imprinted on intermediate transfer belt during monochrome document reading only
when value of 2 is set.
2
NEGA-GST Additional Setting to the Sequence of Preconditioning Exposure (except laser)
0: OFF
1: ON (preconditioning exposure during initial rotations only)
2: ON (Preconditioning exposure during initial rotations and paper interval)
[Factory default/After RAM clear]
Reference Problem occurring when "2" is selected:
- Lower Productivity (=> delay by 2 or 3 seconds)
2
SCR-SLCT Used to select half-tone process for photographic printing paper/photo mode.
0: Use error diffusion method
1: Use low-line-count screen [Factory default/After RAM clear]
2: Use high-line-count screen
2
COPIER>OPTION>BODY