Load the envelopes.
Load the top edge of the
address side (flap side down)
into the sheet feeder.
Align the stack with the right
side of the sheet feeder.
Insert the stack of envelopes
into the sheet feeder until it
stops.
Align the edge of the paper
guide with the left edge of the
stack of envelopes.
Start your print operation.
Make sure the printer is turned on.
Set the envelope properties in the printer driver if necessary.
Normally you specify the envelope settings in your software application.
Remove each envelope.
Remove each printed envelope
as it is ejected from the printer.
3-14
Paper Handling
Chapter 3
Summary of Contents for BJC-6000 Series
