23
12. Reinstall air seal head past the
retaining ring bore and install
retaining ring. Start with one end
of the retaining ring seated in
the bore and work in a circle to
install. It is extremely important
to ensure the clip is fully seated
in to the bore.
13. Reinstall lowers on fork
by feeding fully extended
compression rod and damper rod
into holes in the lowers. Use Blue
Loctite on the bolt threads of both
the rebound knob assembly and
the compression rod nut. Tighten
rebound knob assembly with an
18mm wrench to 7Nm. Tighten
compression rod nut with 13mm
wrench to 5Nm.
14. After the fork is completely
reassembled, it is possible that air
pressure may be trapped in the
lowers causing a vacuum. If this
occurs, equalize the air pressure
in the lowers by passing a zip tie
through the wiper seals on both
legs of the fork while the fork is at
full extension.
Air Internal Travel Adjustment
12.
13.
Plastic
zip tie
Wiper seal
Pinch wiper to insert
zip tie past seal
until bottom out
Both sides
Stanchion
14.
Summary of Contents for Helm MKII
Page 1: ...SUSPENSION FORK INSTRUCTION MANUAL...
Page 3: ...2...
