users.
Candock Inc. disclaims all liability for accidents if the V plate is not
installed.
Tighten the 6 screws
included with the plate in the
inserts for that purpose on the
JetSlide.
BEWARE,
THIS
PLATE
MUST NOT BE INSTALLED ON
THE FIRST JETSLIDE BUT FROM
THE SECOND
.
2)
STABILIZER BAR
To stabilize your JetSlide system and
minimize the lifting of cubes around the
system, a stabilizer bar system was designed.
The positioning of the
stabilizer
bars
is
not
optional.
These
should
always be used when recommended and the use of bars other
than those provided by Candock is prohibited unless written
permission from Candock. The first bar is always installed
between the 1st and 2nd row of cubes in the back. The 2nd
bar is installed between the 3rd and 4th row of cubes. In order
to prevent the lifting of the cubes on the sides, more bars
could be required, install them where needed.
The
fixing
is
done
with
the
hardware kit supplied
with the bars. Pass the
threaded rode through
Candock white bolt
and then place the
washer, lock washer
and nut.
The
tightening
of the stabilizer bars
may
exert
undue
Summary of Contents for G2 JETSLIDE
