CanDock G2 JETSLIDE, Installation And Use Manual

Page: 7 / 18

is running. CANDOCK INC. WILL NOT TAKE ANY RESPONSABILITY
FOR ANY TYPE OF DAMAGE TO A BOAT RESULTING FROM THIS. IT IS
THE RESPONSABILITY OF THE DISTRIBUTOR TO MAKE SURE THAT
THIS IS VERIFIED BEFORE SELLING THE INSTALLATION TO THE
CLIENT.
We recommend that you inform your clients of that even if
you are sure that the intake will be in the water.
9)
The fact of removing cubes at the back of the system to lower the back of the
system closer to the water could exert excessive pressure on the back tabs of
the Jetslide and may cause damage which will not be covered by the
warranty.
10)
All distributors are held responsible for giving training to the customers
on the complete use of the system, theoretical and practical with the
watercraft of the customer. Candock Inc. will not be held responsible for
all damage resulting from the fact that the operator did not receive the
adequate training.
11)
The boats and personnal water crafts must be completely mounted on the
Jetslide at all time. A craft left on the Jetslide in a position where the major
part of the weight is left on the back, could exert excessive pressure on the
back tabs of the Jetslide and may cause damage which will not be covered
by the warranty.
12)
The installation of multiple Jetslides side to side is possible, but no rows of
cubes should be removed with the aim of saving space moreover the totality
of the back Jetslide must be left free to be able to go up and down. Therefore,
it must not be connected to the adjacent systems.
13) It is normal that a certain wear of the JetSlide appears at the points
of contact where the boat exerts more pressure.
III) ACCESSORIES
1) V PLATE
You'll notice that the
installation of in line JetSlides leaves
a gap (in red on the attached image)
at the V of JetSlide. To fill the gap
you must install a V-plate which can
be simply screwed under the JetSlide.
It is very important for the safety of