CanDock G2 JETSLIDE, Installation And Use Manual

Page: 4 / 18

2) ANCHOR
Steps : See ANNEXE B
1)
The JetSlide can simply be attached to an existing dock using rope or
a custom made bracket (ask your dealer). If you tie the JetSlide to an
existing dock, make sure that the dock is sturdy enough to resist the
forward and backward movement generated by the watercraft when
it enters or goes down the JetSlide.
2)
The JetSlide can be added to an existing Candock dock. Make sure
that the dock is anchored well enough to resist the forward and
backward movement generated by the watercraft when it enters or
goes down the JetSlide.
3)
The JetSlide can also be installed by using (two) 2 or (four) 4 pilings
(
See K ). Please note that an installation with 4 piles is not
recommended for PWC’s. If the system is for a boat, the piles at the
back should not be placed in the perimeter covered by the JetSlide
at the back, this could limit its capacity to lower (sink) and will make
going on and off the system more difficult. Ask your dealer for
appropriate parts and instructions. This type of installation should
not be used when water depth is more than 2m / 6’.
4)
The JetSlide can be anchored by using weights and chains ( See L ). It
is very important that the chains stay as tight as possible. Ask your
dealer for recommended weight of anchors and special attachments.
You will have to use galvanized or stainless steel 5/16”chain or good
quality marine rope, the length will depend on water depth and
variations of the water level. When using this type of installation, it
is normal that the JetSlide moves slightly forward when entering the
unit and backwards when exiting the unit. This is why you need to
check regularly the tightness of the chains to limit this movement.