throttle down. For a Jet boat, the pneumatic assisted system will be
required, no matter the weight of the boat.
II)
WARNINGS & SPECIAL INSTRUCTIONS
1)
Like all JetSlide installations, the system should not be installed in
areas subject to waves of more than 0.75m / 2ft regularly. We
recommend an installation in a protected area.
2)
The
installation
of
multiple
JetSlides side to side is possible,
but a minimum of 2 rows of cubes
must be found between each
JetSlide.
An installation with only
one row is possible, but the risk
of damage is possible and the
resulting damage will not be
covered
by
the
warranty.
Contact
Candock
for
more
information.
3)
The handling of several JetSlides assembled in series by lifting (for
winterizing by using a crane for example) is strictly forbidden.
The
excessive inflections will break the tabs of the JetSlide and the
resulting damage will not be covered by the warranty.
Contact
Candock for more information.
4)
The depth of water at the back of the system must be 1m / 3'
minimum at all time to avoid damage to the boats.
5)
Riveted hulls can damage the JetSlide.
6)
Surface can be slippery when the system is wet.
7)
The capacity of the JetSlide may change depending on the type of
assembly, accessories and according to the weight distribution of the
engines.
8)
Please note that some boats have cooling intakes for the engine
which is on the hull and this intake needs to be in the water when
the engine is running. Please make sure that if you are doing a
JetSlide system that this intake will be in the water when the engine
Summary of Contents for G2 JETSLIDE
