Rev 1.0
6
The power supply for operating the analog sensors can also be realized directly via the display. Pin C6
is 5V, and the sensor ground can be obtained from the SensorGround C12. The maximum current of
0.5 amperes should not be exceeded.
Furthermore, the MFD15 Gen2 has two MultiPurpose Pins (
MPPs
). Various functions can be realized
via these pins. Read more in Chapter 7.
Basic settings such as active
TRI file
, can
speed
and termination can be adjusted directly via the
display. If the Can Bus connection is successful, the symbol in the
topbar
is displayed in green, if it is
not successful, the symbol is displayed in red. The
TRI file
is engine-specific and is described in
chapter 8.1.
All further settings are made via Wi-Fi connection via the
oDSS
. By default, Wi-Fi is disabled on the
MFD15 Gen2. The TRI
file
can be edited via the
oDSS
or for
TRI files
for freely programmable engine
ECUs via the
DSS
.
The
oDSS
starts web-based without installation via the browser of your device.
The
DSS
must be downloaded and installed for use. The download is free of charge at
https://www.canchecked.de/downloads-category/dss-display-setup-software/
. The
DSS
is available
for Win32, Win64 and MacOS.
In the meantime, we have produced illustrated installation instructions for numerous vehicles. These
can be found on our website under
www.canchecked.de/help/einbauanleitungen/
. If you have a
CANchecked data display with a plug-and-play OBD data cable, it is recommended to connect it
briefly with the data display to the OBD socket before final installation behind the fairing in order to
check the correct connection and familiarize yourself with the user interface.
