Rev 1.0
28
If set to
MAP
, the values for zero and five volts can be entered. If the data sheet of your sensor only
provides values for 0.5 and 4.5 volts, you can open the calculation tool by clicking on
calculate
to
calculate the corresponding values for zero and five volts.
If set to NTC, you can enter the three constants of your NTC sensor as well as the pull-up resistance.
If you only have three data points, the calculation tool will help you with one click on
calculate
.
While you're at it, you can directly assign the
min
and
max
values of your
sensor
(chapter
If the value of your
analog input
fidgets too much, you have the option of activating the attenuation.
In the case of the
analog inputs
, this is hidden behind the point
Length
.
Figure 35: Attenuation of an analog input
If a 0 is entered here, the value is not damped. The maximum attenuation has a value of 249. A good
starting value for damping is 210.
After you have adjusted all values, you can cache your setup by clicking on A
pply
and then save it
locally on your PC with the
safe to file
button before uploading the modified
TRI
to your data display
via Wi-Fi.
