Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
Clock Setting
In B.U.D.S., select the:
–
Setting
page tab
–
Cluster
page tab.
To set clock to the 24-hour format, check the
24 H
box. To set it to the 12-hour format, leave the box
empty.
If 12-hour format was selected, check the
PM
box
if required.
Set hour and minutes using the up or down ar-
rows.
vmr2016-137-002_a
TYPICAL
1. 24 H box
2. PM box
3. Arrows
Testing the Multifunction Gaugewith
B.U.D.S.
Connect to the latest applicable B.U.D.S. software
version.
Refer to
COMMUNICATION TOOLS
AND B.U.D.S.
subsection.
Wow Test
This function is used to check if the indicator
lights, display and analog indicators (if applicable)
are functional.
NOTE:
This function does not test the signals or
external circuits.
In B.U.D.S., select the:
–
Activation
page
–
Cluster
tab.
Click on the
WOW Test
button.
Indicator Lights Monitoring
In B.U.D.S., select the:
–
Monitoring
page
–
Cluster
tab.
Use the
Cluster Lamp Active
box to monitor dif-
ferent indicator lights outputs.
vmr2016-137-003
TYPICAL - CLUSTER LAMP ACTIVE BOX
This function confirms that the signals are broad-
casting and the indicator lights should be ON in
the multifunction gauge.
Switch Input Monitoring
In B.U.D.S., select the:
–
Monitoring
page
–
Cluster
tab.
Use the
Switch Inputs
box to monitor different
switch inputs as you activates the switches.
vmr2016-137-004
TYPICAL - SWITCH INPUTS BOX
This function confirms that the multifunction
gauge receives the inputs.
Vehicle Parameters Monitoring
In B.U.D.S., select the:
–
Monitoring
page
–
Cluster
tab.
In the upper area of the B.U.D.S. cluster page, the
following indications are displayed.
– Engine speed (RPM)
– Vehicle speed
– Fuel level.
These indications confirm that the applicable sig-
nals are transmitted and the information should be
displayed in the multifunction gauge.
Testing the Multifunction Gauge CAN
Resistor
1. On so equipped models, disconnect DPS1 con-
nector (control) from the DPS module, refer to
STEERING SYSTEM
subsection.
8
vmr2016-410
