II MULTIFUNCTION GAUGE MESSAGES
MESSAGE
PILOT
LAMP(S) ON
DESCRIPTION
DESS KEY NOT
RECOGNIZED
Check engine
Indicates that you have used the wrong ignition key, use the
proper key for this vehicle. It is also possible that the ignition
key has a bad contact, remove and clean key.
PARK BRAKE
Brake lock
Displayed when brake is applied for more than 15 seconds
(while riding).
LO BATT VOLT
Check engine
Low battery voltage, check battery voltage and charging
system.
HIGH BATT VOLT
Check engine
High battery voltage, check battery voltage and charging
system.
LOW OIL
(1)
Check engine
Engine low oil pressure, stop engine immediately.
HI TEMP
Check engine
Engine is overheating, refer to
ENGINE OVERHEATS
in
TROUBLESHOOTING
section.
LIMP HOME
Check engine
Serious fault on the engine that can change the normal
operation of the engine, CHECK ENGINE indicator lamp will
also blink, refer to
TROUBLESHOOTING
section.
CHECK ENGINE
Check engine
Engine fault, CHECK ENGINE indicator lamp will also be ON,
refer to
TROUBLESHOOTING
section.
ECM NOT
RECOGNIZED
Check engine
Communication error between speedometer and engine
control module (ECM), contact an authorized Can-Am dealer.
CHECK DPS
Check engine
Indicates that the DPS (Dynamic Power Steering) does not
work properly. See an authorized Can-Am dealer.
MAINTENANCE
REQUIRED
(2)
None
Displayed in gauge when vehicle is due for a maintenance
TPS FAULT PRESS
OVERRIDE BUTTON
TO LIMP HOME
Check engine
Throttle position sensor does not work properly. See an
authorized Can-Am dealer.
PPS FAULT PRESS
OVERRIDE BUTTON
TO LIMP HOME
Check engine
Faulty throttle lever sensor(s). Refer to
OVERRIDE/DPS
BUTTON
in
CONTROLS
. It may be possible to drive the vehicle
in the limp home mode. See an authorized Can-Am dealer.
NOTICE
(1)
If the message and the check engine light stay on after engine
starting, stop engine. Check engine oil level. Refill if necessary. If the oil
level is good, seek service from an authorized Can-Am dealer, repair shop or
person of your own choosing for maintenance, repair or replacement. Do
not use the vehicle until repaired.
178
______________
Summary of Contents for OUTLANDER 6x6 T 2021 Series
