Can-Am OUTLANDER 6x6 T 2021 Series, Operator'S Manual

Page: 160 / 212

II MAINTENANCE PROCEDURES
22) Brakes
Brake Fluid Reservoir Level
Verification
With vehicle on a level surface, check
brake fluid in reservoirs for proper
level.
NOTE: A low level may indicate leaks
or worn brake pads.
Front Brake Reservoir Level
Verification
Turn steering in the straight-ahead po-
sition to ensure reservoir is level.
Check the brake fluid level, the reser-
voir is full when the fluid reaches of the
top of window.
Visually inspect lever boot condition.
Check for cracks, tears, etc. Replace if
damaged.
vmo2012-012-046_a
TYPICAL
Rear Brake Reservoir Level
Verification
Remove the seat.
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of brake pedal fluid reser-
voir.
vmo2012-012-035_a
1. Rear brake fluid reservoir
Adding Brake Fluid
Clean filler cap.
WARNING
Clean filler cap before removing.
Remove screws retaining the reservoir
cap.
Remove reservoir cap.
Add fluid as required using a clean fun-
nel.
Do not overfill.
NOTICE
Brake fluid can damage
plastic and painted surface. Wipe
off and clean any spillage.
Reinstall reservoir cap and tighten
screws.
NOTE: Ensure filler cap diaphragm is
pushed inside the cap before closing
the brake fluid reservoir.
Recommended Brake Fluid
Always use DOT 4 brake fluid from a
sealed container.
WARNING
To avoid damage to the braking
system, do not use other brake
fluid types.
158
______________