Can-Am MAVERICK Sport MAX Series, Operator'S Manual

Page: 105 / 187

MAINTENANCE PROCEDURES
NOTICE
Maintaining a clean CVT
air filter will maximize air flow for an
optimum CVT components lifespan.
Evaporative Emission
System Pre-Filter (If
Equipped)
Evaporative Emission System
Pre-Filter Replacement
1. Remove rear body module, refer
to
ACCESSING MAINTENANCE
COMPONENTS
.
2. On LH side, remove side panel.
3. Remove the hose clamps.
4. Remove the retaining screws.
5. Remove the pre-filter assembly.
219001880-063_a
1. Pre-Filter
2. Retaining screw
3. Clamps
6. Install a new pre-filter assembly.
TIGHTENING TORQUE
Pre-filter
retaining
screw
2.5 N•m ± 0.5 N•m
(22 lbf• in ± 4 lbf• in )
7. Secure hoses with clamps.
8. Install rear body module and tighten
all screws to specifications.
TIGHTENING TORQUE
Cargo box
retaining
screw
2.5 N•m ± 0.5 N•m
(22 lbf• in ± 4 lbf• in )
Upper cage
extension
screw
Lower cage
extension
screw
24.5 N•m ± 3.5 N•m
(18 lbf•ft ± 3 lbf•ft)
Engine Oil
Engine Oil Level Verification
NOTICE
Operating the engine
with an improper level may severely
damage engine.
NOTICE
Check oil level when en-
gine is cold.
1. Place vehicle on a level surface.
2. Clean around dipstick to avoid for-
eign particles falling down the tube.
3. Unscrew dipstick then remove it
and wipe clean.
219001880-028_a
1. Engine oil dipstick
4. Reinstall dipstick, screw in it com-
pletely.
5. Remove dipstick and check oil level.
It should be near or equal to the up-
per mark.
______________
103