Can-Am MAVERICK Sport MAX Series, Operator'S Manual

Page: 104 / 187

MAINTENANCE PROCEDURES
Secure air filter cover with latches.
Inspect and carefully clean gasket in
the groove of the cover. Replace if
damaged.
219002003-026
RH SIDE OF VEHICLE, UNDER CARGO BOX
1. Air filter cover
2. Latches
3. Duck bill valve
CVT Air Filter
CVT air filter inspection and cleaning
frequency should be adjusted accord-
ing to riding conditions as it is critical
to ensure proper engine performance
and life span.
CVT air filter inspection and cleaning
frequency must be increased for the
following severe riding conditions:
– Riding on dry sand.
– Riding on dry dirt covered surfaces.
– Riding on dry gravel trails or similar
conditions.
– Riding in areas with high concentra-
tion of seeds or crop husks.
– Riding in severe snow conditions.
NOTE: Riding in a group in these con-
ditions would increase even more the
air filter replacement requirement.
CVT Air Filter Removal
Remove screws.
219001880-027_a
CVT Air Filter Inspection and
Cleaning
1. Inspect filter and replace if dam-
aged.
2. Remove the seals.
3. Clean filter and seals using a solu-
tion of soft soap and water, then
rinse.
4. Gently shake off excess water and
allow filter and seals to dry at room
temperature.
5. Clean inside the CVT air inlet with a
vacuum cleaner.
CVT Air Filter Installation
Install seals in CVT filter. Make sure
the upper ends of the seals touch and
there is a gap at the bottom to allow
water to drain.
219001880-069_a
1. Seal touching
2. Gap
Reinstall CVT air filter.
102
______________