Can-Am DS 650 X, Operator'S Manual

Page: 82 / 136

SPECIAL PROCEDURES
Turn Over
When vehicle is turned over or stays
tilted on the side, put the vehicle
back on its wheels, then wait 3 to
5 minutes before starting the engine.
Check RED engine indicator lamp after
restarting the engine. If lamp stays
ON after restarting the engine, stop it.
Air bubbles present in the oil line must
be evacuated. Proceed as follows.
On the LH side, remove the oil inlet
hose on the engine.
V02C4DY
1
1. Oil inlet hose

WARNING
The engine and the engine oil can
be very hot. Wait until engine or
engine oil has cooled off.
Lower oil inlet hose until a little quan-
tity of oil flows without air bubbles.
Replace oil inlet hose and tighten
clamp properly.
Check oil level in oil tank and refill if
necessary.
Start engine. If RED engine indicator
lamp stays ON, stop engine and see
an authorized Can-Am dealer as soon
as possible.
Vehicle Immersion
Should the vehicle become immersed,
it will be necessary to take it to an au-
thorized Can-Am dealer as soon as
possible.
NEVER START THE EN-
GINE!
CAUTION: Immersion of the vehi-
cle can cause serious damage if the
correct restart procedure is not fol-
lowed.
80
______________________