Can-Am DS 650 X, Operator'S Manual

Page: 102 / 136

Squeeze foam to remove excess wa-
ter. Let dry air filter and foam thor-
oughly.
NOTE: Slight dust may be cleaned us-
ing a low-pressure airgun. Blow com-
pressed air backward of operating air
flow.
If air filter element or foam is dirty,
replace with a new one.
When the filter is dried, re-oil with air
filter oil (P/N 219 700 340) or an equiv-
alent.
Installation
Properly reinstall removed parts in the
reverse order of their removal.
Valves Adjustment
See an authorized Can-Am dealer for
valves adjustment.
Insufficient clearance will cause loss
of power and possibly damage the
valves.
Excessive clearance will
cause noise.
Spark Arrester
The muffler must be periodically
purged of accumulated carbon. See
the
MAINTENANCE CHART .
Removal

WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust sys-
tem is very hot. Make sure that
there are no combustible materi-
als in the area. Wear eye protec-
tion and gloves. Never stand be-
hind the vehicle while purging ex-
haust system. Respect all applica-
ble laws and regulations.
Remove:
– the screws retaining the spark ar-
rester to the muffler
V02C06Y
1
2
1
1. Screws
2. Spark arrester
– spark arrester and sealant joint
V02C07Y
1
2
3
1. Spark arrester
2. Sealant joint
3. Muffler
– inner grill with wool.
Remove all carbon deposit in the muf-
fler.
Remove carbon deposits from the
spark arrester using a brush.
NOTE: Use a soft brush and be careful
to avoid damaging spark arrester.
100
_____________________