Can-Am DS 650 X, Operator'S Manual

Page: 77 / 136

V02C3NY
3
1
2
1. Full
2. Add
3. Operating range
To add oil, remove the dipstick. Place
a funnel into the dipstick tube to avoid
spillage.
Add a small amount of oil and recheck
oil level.
Repeat the operation until oil level
reaches the dipstick’s upper mark.
Do not overfill.
Properly tighten dipstick.
Engine Coolant
Recommended Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specifi-
cally for internal combustion aluminum
engines.
Cooling system must be filled with
BRP premixed coolant (P/N 219 700
362) or with distilled water and an-
tifreeze solution (50% water, 50% an-
tifreeze).
Coolant Level

WARNING
Check coolant level with engine
cold. Never add coolant in cool-
ing system when engine is hot.
V02A08Y
2 1 3
1. Coolant reservoir
2. Radiator
3. RH front shock
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir.
NOTE: When checking level at tem-
perature lower than 20°C (68°F), it
may be slightly lower than MIN. mark.
Remove filler cap then add coolant up
to MAX. mark if required. Use a funnel
to avoid spillage.
Do not overfill.
Properly reinstall and tighten filler cap.
If coolant is added in the coolant reser-
voir, check the level in the radiator too.
Add coolant if necessary.

WARNING
In order to avoid potential burns,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Can-Am dealer.
Coolant Replacement
Refer to MAINTENANCE section.
_____________________
75