![background image](http://html1.mh-extra.com/html/campbell/skyvue-8m/skyvue-8m_product-manual_489150066.webp)
5.2 Restoring factory defaults
Restore factory defaults by using the DEFAULTS command in the terminal mode.
Hard Reset
Alternatively, use the RESET push switch on the DSP to restore factory defaults (
61).
WARNING:
Opening the access lid MUST be carried out by a competent person, who has sufficient
training, experience and knowledge both in electrical safety and the detail and operation of
the sensor.
WARNING:
Opening the access lid may expose hot surfaces.
Use a narrow tool such as a screw driver to reach the reset switch.
If the reset switch is pushed for four seconds, the SkyVUE 8M will reboot in exactly the same way
as the REBOOT terminal command. If it is held closed while the SkyVUE 8M is powered off and
on again, it will return to factory defaults. To power cycle the SkyVUE 8M, disconnect the battery
and switch the main power off and on.
FIGURE 5-1. Restoring factory defaults
SkyVUE™8M Tactical LIDAR Ceilometer
61