Campbell NL200, Instruction Manual

Page: 18 / 61

NL200/201 Network Link Interface
7
FIGURE 4-3. Bridge Mode disabled
Some reasons you might want to use each of these modes are described below.
Refer to Section
6 ,
Configuring the NL200/201
(p. 10)
, and Section 7 ,
Operation
(p. 12)
, for information on setting up your NL200/201 for each mode.
Campbell Scientific’s
LoggerNet
software is used to communicate with the
dataloggers once the NL200/201 is configured properly and connected to a
network.
Bridge Mode
x
Allows access to datalogger’s internal IP functionality when a peripheral
port is not accessible. For example accessing the HTTP/webpage, email,
and FTP capabilities of a CR800/850, ET107, RAWS, or CS110.