Campbell CC5MPXWD, Instruction Manual

Page: 44 / 126

CC5MPX Digital Camera
32
TABLE 8-5. Ethernet Power Save Modes
Camera
Power
Mode
Ethernet
Power Save
Mode Operating Characteristics
Fully On
Always On
• Camera is always on.
• Highest power consumption.
• Ethernet is on and always available for incoming communications.
Moderate
Power Save
• Not recommended.
Full Power
Save
• Camera is always on.
• Average power consumption is reduced by 50 mA @ 12 Vdc.
• Ethernet is normally turned off and is only enabled when outgoing
communications are required (email or FTP).
• User needs to push the
Setup button to temporarily enable the Ethernet port
for web page access.
Partially On
Always On
• The camera is effectively off in a low powered state.
• Typical power consumption is 80 mA @ 12 Vdc.
• Ethernet is always on and always available for incoming communications.
• The camera will temporarily wake up to the Fully On power mode when
traffic occurs on the network. In situations where there is constant network
traffic, the camera may effectively be in the Fully On power mode.
Moderate
Power Save
• The camera is effectively off in a low powered state.
• Typical power consumption is 80 mA @ 12 Vdc.
• Ethernet is always off.
• Disconnecting and connecting the camera to another Ethernet device will
momentarily wake up the camera to allow it to process incoming
communications. The camera will go into the low powered mode again if no
communications occur.
Full Power
Save
• The camera is effectively off in a low powered state.
• Average power consumption is typically 10 mA @ 12 Vdc.
• The Ethernet is normally turned off and is only enabled when outgoing
communications are required (email or FTP).
• User needs to push the
Setup button to temporarily enable the camera and
Ethernet port for web page access.
• The camera can respond to RS-232 and RS-485 communications in this
mode.