CC5MPX Digital Camera
103
Run the execufile usbconf.exe.
FIGURE 10-3. Network Configurations
At this point, confirm or edit the IP address settings. If changes are made, the
Apply
button must be selected followed by
Exit
.
Do not unplug the USB
cable or shut down the camera at this point.
The USB device must be safely
removed before unplugging the cable or shutting down the camera, otherwise
the changes will be lost.
10.2 Quick Notes
10.2.1 CC5MPX General
•
The LED will flash or be on when the camera is in an Active Power state.
•
When the LED is steadily on, the camera is booting up. Avoid interrupting
this process.
•
Briefly pressing the
Setup
button will always cause the camera to exit
from any low powered quiescent states and enable the Ethernet interface
for communications. The camera will remain in this state for 5 minutes.
•
An active session to the camera with a web browser will prevent the
camera from entering a low powered state.
•
Avoid removing power from the camera when it is in an active state. If the
camera is in an active state (LED is flashing), properly shut down the
camera to avoid any memory card corruption before removing power. The
camera can be shut down by pressing the
Setup
button continuously for
more than 10 seconds or by using the
Shutdown
button on the web
interface.
•
The SD memory card must be formatted to FAT32.
•
If a memory card is removed from the CC5MPX to read or download its
contents, do not delete or add files manually. If files need to be deleted, it
is recommended to reformat the entire card (using FAT32) or to use the
CC5MPX web interface to delete them.
•
Verify that the lens cable is properly seated, as the connector may
inadvertently become unplugged during handling or installation.
Summary of Contents for CC5MPXWD
