Campbell CC5MPXWD, Instruction Manual

Page: 32 / 126

CC5MPX Digital Camera
20
When the protective cap is removed, a standard cable with an RJ45 connector
can be used to connect the camera to another device in an indoor environment
or temporarily outdoors if weather permits.
If a permanent Ethernet connection is required outdoors or if a connection is
required in wet or harsh locations, the Environmental Ethernet Cable must be
used.
The maximum cable length for the Ethernet cable is 70 m (230 ft).
The CC5MPX does not support the PakBus communication
protocol over Ethernet.
8.2.2 Power and I/O Connection
Connection to the Power and I/O connector is necessary for camera operation
and it is the only means to supply power to the camera. The connector that
connects to the Power and I/O connector provides a weather tight connection
and has an IP67 environmental rating when properly connected.
When making the cable connection to the camera, the notch positions should
always be lined up and care should be taken to not cross thread the connector.
8.2.3 Setup Button/Status LED
The Setup button is located behind a protective metal cap on the camera. The
Setup
button also contains an integrated Status LED for user feedback.
To access the LED, unscrew the protective cap to expose the button/LED. It is
highly recommended to place the protective cap back on for improved
environmental protection.
8.2.3.1 Status LED
The Status LED located in the center of the button provides some useful
diagnostic information about the camera. TABLE 8-3 describes the LED
behavior.
NOTE