WHAT TO DO IF YOU SMELL GAS.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department. Installation and service must be performed by a
qualified installer, service agency or gas supplier.
WARNING
DO NOT use this fire pit in a manner other than its intended
purpose. Not intended for commercial use. Not intended
to be installed or used in or on a recreational vehicle or
boat. Keep a fire extinguisher accessible at all times. The
use of alcohol, prescription or nonprescription drugs may
impair the consumer’s ability to properly assemble or safely
operate this fire pit. Solid fuels shall not be burned in this
gas fireplace.
FOR OUTDOOR USE ONLY!
Do not operate the fire pit indoors, in a garage, or in any other
enclosed area or under overhead construction. Do not operate
fire pit near flammable materials such as decks, fences,
porches or carports. A minimum clearance range of 72” inches
is recommended. Do not use the fire pit near gasoline or other
combustible liquids or where combustible vapors may be
present.
Children and adults should be alerted to the hazards of high
surface temperatures and should stay away to avoid burns or
clothing ignition. Young children should be carefully supervised
when they are in the area of the appliance. Clothing or other
flammable materials should not be hung from the appliance, or
placed on or near the appliance. Any guard or other protective
device removed for servicing the appliance must be replaced
prior to operating the appliance.
Installation and repair should be done by a qualified service
person The appliance should be inspected before use and at
least annually by a qualified service person. More frequent
cleaning may be required as necessary. It is imperative that
control compartment, burners and circulating air passageways
of the appliance be kept clean.
Use caution when assembling and operating fire pit to avoid
cuts and scrapes from rough or sharp edges.
DO NOT move the fire pit while it is in use. Allow the fire pit to
cool completely before moving or storing.
When in use, the fire pit must be on a level, stable surface
in an area clear of combustible material. An asphalt surface
(blacktop) may not be acceptable for this purpose. Do not
operate fire pit on flammable material such as carpet or a wood
deck. Store the fire pit in a dry, protected location.
This fire pit is not intended for and should never be used as a
heater.
DO NOT leave fire pit unattended while in use. Operate the fire
pit with close supervision.
DO NOT operate around children or animals.
DO NOT bump or tip fire pit. If fire pit becomes extremely hot,
allow fire pit to cool completely before handling. If you must
handle the fire pit while it is hot, always wear protective oven
mitts or heat resistant gloves when handling the fire pit or its
components.
DO NOT obstruct flow of combustion air and/or ventilation air
for fire pit.
DO NOT wear loose clothing while operating the fire pit. Tie
back long hair while operating the fire pit. ALWAYS wear fully
covering shoes while operating the fire pit.
Allow fire pit and its components to cool completely before
conducting any routine cleaning or maintenance. Do not move
the fire pit when in use. Allow the fire pit to cool before moving
or storing.
DO NOT use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
DO NOT use if winds are causing the flames to lap over the top
of the fire pit.
An LP cylinder not connected for use should not be stored in
the vicinity of fire pit or any other fire pit. Do not store spare LP
cylinders within 10 feet of fire pit. LP cylinders must be stored
outdoors, out of reach of children. Do not store a spare LP-gas
cylinder under or near this fire pit. Never fill the cylinder beyond
80 percent full. Failure to follow these instructions exactly could
result in a fire causing death or serious injury.
While the fire pit is not in use, the gas must be turned off at the
supply cylinder. The fire pit should be shut off and all supply
valves (on piping or on fuel cylinders) should be closed in the
event that the odor of unburned gas is detected. Do not attempt
to use the unit until any gas leaks are fixed. Do not use the fire
pit if the burner fails to light or fails to remain lit. Under such
conditions, gas should be shut off and fuel cylinders should be
disconnected. Do not operate under high wind conditions. All
installations are to conform to local codes. In the absence of
local codes, installation should conform to the National Fuel
Gas Code, ANSIZ223.1/NFPA 54
CONNECTING THE LP TANK
1. The knob on the LP tank must be
closed. See that the knob is turned
clockwise to a full stop.
2. Check that the control knob on the fire
pit is turned off.
3. Remove the protective cap from the LP
tank valve and coupling nut, if present.
4. Hold the regulator in one hand and
insert the nipple into the valve outlet. Be sure the nipple
is centered in the valve outlet. The coupler connects to the
large outside threads on the valve outlet
