CAME T6N, Manual

Page: 49 / 112

P
age
21
- Manual
FA01732-EN
- 07/2022 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Partial opening
To adjust partial opening, see [Settings].
DIP-switch 12 ON After a partial opening command, automatic closing is fi xed at 8 seconds
DIP-switch 12 OFF After a partial opening command, automatic closing can be adjusted from the trimmer.
Only with automatic closing active.
DIP-switch 13 ON Safety devices test
Check that the photocells connected to the inputs are operating correctly, after each opening and
closing command.
Additional light
Choose the operating mode of the lighting device connected to the E - EX output.
DIP-switch 16 ON Courtesy light
The light switches on when a manoeuvre starts and remains on once the manoeuvre has fi nished
for 330 seconds.
DIP-switch 17 ON Cycle lamp
The lamp stays on during the manoeuvre.
DIP 18 ON Support brake
Activate brake function during closing. Only use with CBX and CBXT operators.
Settings
+ T.C.A - + AP.PARZ. -
1
Adjusting automatic closing time
The trimmer is used to set the time before automatic closure, once the opening travel end point has been reached or once the
photocells have caused a partial stop [C3].
Set to between 1 and 120 seconds.
2
Adjusting partial opening
Set to between 1 and 14 seconds.