CAME T6N, Manual

Page: 47 / 112

P
age
19
- Manual
FA01732-EN
- 07/2022 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
PROGRAMMING
Function of the DIP switches
DIP switches FUNCTION
1 Automatic closure
2 Sequential and step-by-step command
3 Open command
4 Hold-to-run
5 Pre-fl ashing
6 Obstacle with motor stopped
7 Input C1
8 CX input
9 CX input
10 Total stop
11 [do not use, keep OFF]
12 Partial opening
13 Safety devices test
14 Input C1
15 CX input
16 Additional light
17 Additional light
18 Support brake
19 [do not use, keep OFF]
20 [do not use, keep OFF]
Functions menu
DIP-switch 1 ON Automatic closure
Activate automatic closing.
The function does not work if any of the safety devices are triggered when an
obstacle is detected, or after a complete stop, or during a power outage.
To adjust the automatic closing time, see [Settings].
DIP-switch 2 ON Sequential
Enable sequential command from control device (2-7) and transmitter.
Sequential - The fi rst command is to open, the second to STOP, the third to close and
the fourth to STOP.
DIP-switch 2 OFF Step-by-step
Enable step-by-step command from control device (2-7) and transmitter.
Step-by-step - The fi rst command is to open and the second to close.
DIP-switch 3 ON Open
Enable the opening command from the transmitter.