Chapter 5: Preparing for installation
Configuring Link for Test
Page 5-17
Perform the following procedure to toggle the computer to
not
use the proxy setting.
Procedure 3
Bypassing browser proxy settings to access module web pages
1
Launch Microsoft Internet Explorer
2
Select
Tools, Internet Options, Connections, LAN Settings.
Alternate web browser
menu selections may differ.
3
Uncheck the
Use a proxy server
box.
In the address bar of your browser, enter the IP address of the AP/BHM. (For example, enter
http://169.254.1.1
to access the AP/BHM through its default IP address). The AP/BHM responds
by opening the General Status tab of its Home page.
Logging into the web interface – AP/SM/BH
Procedure 4
Logging into the web interface
1
Plug one end of a CAT 5 Ethernet cable into the AP/BHM
2
Plug the Ethernet cable connector labeled To Radio into the jack in the pig tail that hangs
from the power supply.
3
Plug the other connector of the pig tail (this connector labeled To Computer) into the
Ethernet jack of the computing device.
4
Plug the power supply into an electrical outlet.
Warning
From this point until you remove power from the ODU, stay at least as far
from the ODU as the minimum separation distance specified in
Minimum
separation distances
on page
5-3
.
Using the Quick Start Configuration Wizard of the
AP/BHM
See section
Quick link setup
on page
7-11
.
Summary of Contents for PMP 450 AP
