Cambium PMP 450 AP, User Manual, Page: 269 / 301

Chapter 6: Installation Installing the copper Cat5e Ethernet interface
Page 6-22
Install the LPU to PSU drop cable
Use this procedure to terminate the bottom LPU to PSU drop cable with RJ45 connectors at both ends,
and with a cable gland at the LPU end.
Warning
The metal screen of the drop cable is very sharp and may cause personal injury. ALWAYS
wear cut-resistant gloves (check the label to ensure they are cut resistant). ALWAYS wear
protective eyewear. ALWAYS use a rotary blade tool to strip the cable, not a bladed knife.
Caution
Check that the crimp tool matches the RJ45 connector, otherwise the cable or connector
may be damaged.
1 Cut the drop cable to the length required from bottom LPU to PSU.
2 At the LPU end only :

Fit one cable gland and one RJ45 connector by following the procedure Terminate with RJ45
connectors on page 6-20 .

Connect this cable and gland to the bottom LPU.
3 At the PSU end only : Do not fit a cable gland. Strip the cable outer sheath and fit the RJ45
connector load bar. Fit the RJ45 connector housing. To ensure there is effective strain relief, locate
the cable inner sheath under the connector housing tang: