Cambium PMP 450 AP, User Manual

Page: 239 / 301

Chapter 5: Preparing for installation Testing system components
Page 5-9
Equipment to Be
Installed Tools Required
SM

Wrench/driver (depending on operator’s choice of clamps)
Used for tightening clamps to the pole

Alignment tone adapter / headset
Used for aligning the SM to the AP
Universal Global
Positioning System

Philips Screwdriver
Used for attaching the UGPS unit to the pole/mast mounting bracket

13mm Spanner Wrench (or Ratchet Spanner Wrench)
Used for connecting the mounting bracket’s U-bolt to the antenna or mast
Cabling

Electrician’s Scissors or Wire Cutters
Used for cutting wire to length

RJ-11/RJ-45 Crimping Tool
Used for stripping RJ-11/RJ-45 cables and for terminating cable ends

Cable Testing Device
Used to ensure that cables are properly constructed
Standards for Wiring
Modules automatically sense whether the Ethernet cable in a connection is wired as straight-through or
crossover. Operators may use either straight-through or crossover cable to connect a network interface
card (NIC), hub, router, or switch to these modules. This guide follows the EIA/TIA-568B colour code
standard.