Parameter
Name
Description
General
Note
Enter here the Name of the LFTXRX chassis. This name will be displayed
on the top of the State page.
Date/ Time
If you want to set the Date and/ or the Time, type the actual Date and
Time in the following syntax: YYYY-MM-DD HH:MM:SS It is not possible to
change only one of both parameters. The sat-nms LFTXRX real time
clock is backed up by a gold-cap capacitor. The gold cap supplies the
RTC chip with power for several days if the main power is missing. If the
off time periode to long the Date/ Time have to be set again.
Refresh rate
Here you can configure the automatic refresh time for the
Master Ch.
and
the
Slave Ch.
pages. You can choose between 1s, 3s, 5s and 10s.
RS232 Baud
rate
select here the bit rate for the RS232 Interface. You can choose between
9600, 19200, 38400, 57600, 115200 baud
RS232
Address
This parameter defines the communication address to be used with the
serial interface. You may select an address 'A' .. 'G' for the packet mode
communication protocol or 'NONE' to switch the communication mode to a
plain text protocol.
SNMP
Configuration
Read
Community
Sets the SNMP community string expected for read access. The default is
'public'.
Write
Community
Sets the SNMP community string expected for write access. The default is
'public'.
Trap
Community
Sets the SNMP community string sent with traps. The default is 'public'.
Trap
Destination IP
1
Enter the trap destination IP address (dotted quad notation) to make the
unit sending traps by UDP to this host. Setting the parameter to 0.0.0.0
disables the trap generation.
Trap
Destination IP
2
Enter the trap destination IP address (dotted quad notation) to make the
unit sending traps by UDP to this host. Setting the parameter to 0.0.0.0
disables the trap generation.
Trap
Destination IP
3
Enter the trap destination IP address (dotted quad notation) to make the
unit sending traps by UDP to this host. Setting the parameter to 0.0.0.0
disables the trap generation.
Trap
Destination IP
4
Enter the trap destination IP address (dotted quad notation) to make the
unit sending traps by UDP to this host. Setting the parameter to 0.0.0.0
disables the trap generation.
System
Location
The unit replies to MIB-II sysLocation requests with the text entered at this
place.
(C) 2021, SatService GmbH
www.satnms.com
LF20-UM-2107 Page 27/43
