Calian SatService sat-nms LF20, User Manual

Page: 22 / 44

If a LFSW card is installed, you can read the following parameters:
Parameter
Name
Description
Remote
It is possible to change some settings of the LFTX card remote (e.g. via web
browser interface) or local (only on the front panel of the card). The current
state of the hardware remote/local switch on the corresponding card is shown
here.
Protection
This parameter shows if the protection is active (ON) or (OFF). If the
protection is ON, the card will switchover to the standby card if a fault occurs
in the active card.
Switch
Position
The switch postion displayes the actual position setting A or B path.
No. Card
Pos A
Display the Slot number of switch position A. This is a 'Config Parameter' in
the software but also the hardware interconnection from the switch connector
A to the slot with the defined number have to be done.
No. Card
Pos B
Display the Slot number of switch position B. This is a 'Config Parameter' in
the software but also the hardware interconnection from the switch connector
B to the slot with the defined number have to be done.
Protection
State
The protection state displays, if a redundancy switching has been performed
with a button labled 'switched'. By pressing the button the state can be
reseted.
3.2.4 Reading of empty slots
(C) 2021, SatService GmbH www.satnms.com LF20-UM-2107 Page 21/43