sat-nms ACU-ODU DC Version User Manual
Version 5.0.002 -- 2021-07-29 -- © 2003-2021 SatService GmbH
Abstract
The sat-nms ACU-ODU is a full featured antenna positioner and as an option antenna
tracking system. The electronics of the sat-nms ACU-ODU is build into an outdoor cabinet.
The protection class of the cabinet is IP66 if no optional air ventilation is installed. So it is no
problem to install it outside without any additional roof.
This document describes how to install, setup and operate this antenna controller.
Table Of Contents
1 Introduction
2 Safety Instructions
3 The sat-nms ACU-ODU DC
3.1 sat-nms ACU-ODM
3.2 Power supplies for sat-nms ACU-ODM
3.3 Power supply for motor drivers
3.4 Motor drivers
3.5 Circuit breakers
3.6 Contactor
3.7 Terminals
3.8 Heater
3.9 Optional air ventilation
4 Installation
4.1 Mechanical installation
4.2 Interfaces to the Antenna, Pin descriptions
4.2.1 Angle encoder connection
4.2.2 Limit switch and emergency switch connection
4.2.3 Motors connection
4.2.4 Mains connection
4.2.5 Ethernet connection
4.3 Start-up
4.3.1 Setting the IP Address
4.3.2 Limit switches
4.3.3 Angle detectors
4.3.4 Motors
4.3.5 Pointing/ Tracking
4.3.6 Backup of ACU settings
5 Operation
5.1 The Web-based User Interface
5.2 Antenna Pointing
5.3 Target Memory
5.4 Tracking Parameters
5.5 Test Page
5.6 Setup
(C) 2022, SatService GmbH
www.satnms.com
ACU-ODU-DC-UM-2209 Page 3/67
