LBK-10-SW Barbecue Island
LTR50001142, Rev. A
Appendix
www.calflamebbq.com
33
Disconnect or shut off the LP or natural gas line
1.
connected to the grill. Wait until the burners cool
down.
Open the hood and remove the grate and flame
2.
tamer on top of the stainless steel burner you
want to replace.
Through the access door underneath the grill,
3.
find the round stud and locking pin that locks the
burner you want to replace.
Carefully remove the locking pin with your
4.
fingers.
Raise the stud from the locking hole and carefully
5.
move the burner forward to release it from the
igniter and gas supply valve.
Take the burner out of the grill and store it in a
6.
safe and dry place.
Install the Sear Zone burner. Align the gas inlet
7.
on the burner with the gas supply valve on the
grill and torch tube with the igniter. Make sure
they align perfectly. Slide the stud at the other
end into the locking hole.
Adjust the Sear Zone burner, make sure the
8.
burner is aligned and in position.
Install the locking pin. Through the access door
9.
underneath the grill, find the stud to lock the
burner in place, install the locking pin. Make sure
the locking pin is secured correctly.
Repeat steps 2 through 9 if you want to replace
10.
other burners.
Put back the grate you just removed. (You don’t
11.
need flame tamers for Sear Zone burners.)
Reconnect or turn on the gas line.
12.
If you want to change Sear Zone burners to regular
burners, just follow the above procedure above in a
similar way.
Installing Sear Zone Burners
