LBK-10-SW Barbecue Island
LTR50001142, Rev. A
Appendix
www.calflamebbq.com
29
You will need:
6mm socket or nut driver
•
Two to five 1.9mm orifices (depending on your
•
grill
Pipe compound suitable for natural gas
•
Remove the grates, flame tamers, and drip tray
a.
from the grill. See figure below.
Remove the locking pins from the end of the
b.
burners.
The locking pins are accessible by removing
the drip tray and tilting the grill back. They can
be seen underneath the grill in the back. See
figures below.
Remove all burners by carefully lifting them up
c.
and away from the valve orifice.
Using a 6mm socket or nut driver, remove the
d.
orifice for the burner.
Apply a small amount of pipe compound to the
e.
orifice threads.
Screw in the orifice until it is finger tight.
f.
Tighten the orifice with the 6mm wrench.
g.
Repeat the above steps for the remaining
h.
burners.
Replace the burners, flame tamers, drip tray, and
i.
grates.
You do not need to replace the locking pins. They
are used to keep the burners in place during
shipping and are not necessary to operate your
grill.
WIDTH
WIDTH
WIDTH
WIDTH
Minimum
Clearance
12” Minimum Distance
Between Grill and Side Burner
Minimum
Clearance
Screen Vents
WIDTH
WIDTH
WIDTH
DEPTH
WIDTH
WIDTH
DEPTH
WIDTH
WIDTH
WIDTH
DEPTH
DEPTH
DEPTH
HEIGHT
HEIGHT
HEIGHT
Burner
Locking Pin
Burner
Locking Pin
Orifice
Step 2: Changing the burner orifices
Replace the main burner orifices
1 .
