LBK-10-SW Barbecue Island
LTR50001142, Rev. A
Using
Your Grill
www.calflamebbq.com
15
Each time you light the grill, check the following:
Inspect the hose before using the grill. If there is excessive abrasion or wear, or if the hose is cut, it must
•
be replaced prior to using the grill. See page 6 for LP connection instructions and specifications. If you need
a replacement hose, contact your Cal Flame dealer.
Ensure the area around the barbecue is clear of flammable substances such as gasoline, yard debris, wood,
•
etc.
Ensure there is no blockage of the airflow through the vent space located below the face of the unit.
•
When using propane gas, keep the special ventilation openings in the enclosure free and clear of debris.
•
If connected to a propane cylinder, carefully inspect the rubber hose attached to the regulator before each
•
use.
Ensure the propane cylinder, regulator, and rubber hose are installed in a location not subject to heating
•
above 125º F (51º C).
Ensure the burner flames burn evenly along both sides of each burner with a steady flame (mostly blue with
•
yellow tipping). If burner flames are not normal, check the orifice and burner for insects or insect nests.
Ensure the in-line gas valve or gas cylinder valve is always shut OFF when the barbecue is not in use.
•
Do not operate the side burner with its cover closed or the back burner with its cover installe
•
d.
Lighting the Burners
Electronically Lighting the Burners
Manually Lighting the Burners
Open the hood.
1.
Keep your face as far away from the burners as
2.
possible.
Press and rotate the burner knob counter
3.
clockwise past the light position to HIGH. You
will hear a loud click as the electronic lighter
produces a spark.
Listen for the sound of the gas igniting. If the
4.
burner does not light on the first try, repeat
immediately.
If the burner does not light after three attempts,
5.
turn the control knobs to the OFF position.
Wait five minutes until the gas clears before
attempting to light it again.
Repeat the procedure or try the manual lighting
6.
procedure below.
Upon successful lighting, repeat the process on
7.
the other burners you wish to light.
To shut off the burners, rotate the knob and turn
8.
to OFF. It is normal to hear a popping sound
when the burners are turned off.
WARNING: Do not use standard matches or cigarette
lighters to perform match lighting procedures.
Serious burns can occur and lighters can explode.
Open the hood.
1.
If you have just attempted to light the burner,
2.
allow five minutes for any accumulated gas to
dissipate.
Slide out the drip tray from the grill.
3.
Keep your face as far away from the burners as
4.
possible.
Light and insert a long stem match, holding it
5.
near the burner ports.
Push in and turn the control knob just past the
6.
LIGHT position to HIGH.
Listen for the sound of the gas igniting. If the
7.
burner does not light after five seconds, turn
the control knobs to the OFF position. Wait five
minutes until the gas clears before attempting
to light it again.
If the burner does not light after several
8.
attempts see Troubleshooting Guide in the back
of this manual.
