PN MN236 A | User Manual 15 - ENG
Sprint / Stroller / Hi Flow Stroller
Table 4
Guidance and Manufacturer’s Declaration—Immunity ME Equipment and ME Systems
Guidance and Manufacturer’s Declaration—Immunity
The Sprint/Stroller/Hi Flow Stroller is intended for use in the electromagnetic environment specified
below. The customer or user of the Sprint/Stroller/Hi Flow Stroller should ensure that it is used in such
an environment.
Immunity Test
IEC 60601 Test Level
Compliance Level
Electromagnetic Environment—Guidance
Conducted RF IEC
61000-4-6
Radiated RF IEC
61000-4-3
3 Vrms
6 Vrms (In ISM Bands)
150 kHz to 80 MHz
80 MHz to 2.7 GHz
Not applicable
Battery powered
device, No SIP/SOP
10 V/m
80 MHz—2,7 GHz
80 % AM at 1 kHz
Portable and mobile RF communications equip-
ment should be used no closer to any part of
the Sprint/Stroller/Hi Flow Stroller, including
cables, than the recommended separation dis-
tance calculated from the equation applicable
to the frequency of the transmitter.
Recommended separation distance
d = 1,2
√
P
d = 1,2
√
P
d = 2,3
√
P
where P is the maximum output power rating
of the transmitter in watts (W) according to the
transmitter manufacturer and d is the recom-
mended separation distance in meters (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey
a
,
should be less than the compliance level in
each frequency range
b
.
Interference may occur in the vicinity of equip-
ment marked with the following symbol:
Test frequency
(MHz)
Band
a)
(MHz)
Service
a)
Modulation
b)
Maximum
power (W)
Distance
(m)
Immunity Test
Level (V/m)
385
380–390
TETRA 400
Pulse modulation
b)
18 Hz
1.8
0.3
27
450
430–470
GMRS 460, FRS 460
FM
C)
±5 kHz deviation
1 kHz sine
2
0.3
28
710
704–787
LTE Band 13, 17
Pulse modulation
b)
217 Hz
0.2
0.3
9
745
780
810
800–960
GSM 800/900, TETRA
800, IDEN 820, CDMA
850, LTE Band 5
Pulse modulation
b)
18 Hz
2
0.3
28
870
930
1720
1700–
1900
GSM 1800; CDMA 1900;
GSM 1900; DECT; LTE
Band 1, 3, 4, 25; UMTS
Pulse modulation
b)
217 Hz
2
0.3
28
1845
1970
2450
2400–
2570
Bluetooth, WLAN, 802.11
b/g/n, RFID 2450, LTE
Band 7
Pulse modulation
b)
217 Hz
2
0.3
28
5240
5100–
5800
WLAN 802.11 a/n
Pulse modulation
b)
217 Hz
0.2
0.3
9
5500
5785
NOTE: If necessary to achieve the IMMUNITY TEST LEVEL, the distance between the transmitting antenna and
the Sprint/Stroller/Hi Flow Stroller may be reduced to 1m. The 1m test distance is permitted by IEC 61000-4-3.
a
For some services, only the uplink frequencies are included.
b
The carrier shall be modulated using a 50% duty cycle square wave signal.
c
As an alternative to FM modulation, 50% pulse modulation at 18 Hz may be used because while it does not represent actual modulation, it
would be worst case.
