![Cafection Encore 29 Service & Installation Manual Download Page 57](http://html1.mh-extra.com/html/cafection/encore-29/encore-29_service-and-installation-manual_3297721057.webp)
EN1805CMINSA Rev. 5 2021-10
57
www.cafection.com 800-561-6162
SERVICE & INSTALLATION MANUAL - Encore 29
C
le
an
in
g
an
d
San
it
iz
in
g
7.7.3 Waste Bin
Frequency: daily or every 40 cycles
After each coffee cycle, the spent
grounds and used filter paper are
automatically discarded into the
waste bin. To prevent the bin from
overflowing, an automatic function
disables coffee-based beverages and
displays a message on the screen.
Default setting = 40
Maximum setting = 400
Minimum setting = 0
When using the internal waste bin provided with the unit, Cafection recommends
setting the counter to a maximum of 40 cycles using standard 8, 10 and 12 oz cups.
If the setting is too high, the wasted filter paper could jam in the brew group and
damages may occur.
Setting the maximum counter to zero (0) disables the automatic function and may
cause an overflow issue if the waste bin is full.
The equipment will not dispense coffee beverages until the bin is emptied and the counter
is resetted. The counter settings can be adjusted in accordance to the size of the waste
bin in the Settings sub tab, under the System tab in Service mode (see section 6.6.1).
How to empty the cabinet’s waste bin
1. Open the cabinet’s door, below the brewer.
2. Open the brewer’s door and remove the front panel.
3. Cut the filter paper 4" below the brew group with scissors or tear gently.
DO NOT
YANK ON THE PAPER!
4. Remove the filled garbage bag from the waste bin and replace it with a new one.
5. Reinstall the front panel and close the doors.
6. Access Service mode and press the "Reset Waste Bin" button.
How to empty the brewer’s internal waste bin
1. Open the brewer’s door.
2. Take off the front panel.
3. Cut the filter paper 4” below the brew group with scissors or tear gently.
DO NOT
YANK ON THE PAPER!
4. Disengage the spout so there is room to pull the waste bin out of the machine.
5. Remove the internal waste bin, empty it and replace it inside the machine.
6. Reinstall the front panel and the spout, then close the door.
7. Access Service mode and press the "Reset Waste Bin" button.
It is very important not to yank on the filter paper. Doing so may result in a
malfunction of the machine.