Document type:
Title:
Revision date:
Revision:
Installation Guide (MUT)
Mod. SY1527, universal multichannel power supply system
03/12/02
3
NPO:
Filename:
Number of pages:
Page:
00103/97:1527x.MUTx/03 HWGUIDE_REV3.DOC
62
50
7. Hardware installation and set-up
7.1 Installation
Before installing the system, make sure you have read thoroughly the safety rules and
installation requirements listed in Section 6, p.47.
For the installation of the SY1527 system in its basic standalone configuration, the
following parts are needed (see also the Check List at page 46):
•
SY1527 mainframe;
•
Primary Power Supply (Model A1531);
•
Power Supply Unit (Model A1532), from a minimum of one Unit to a maximum of
3 Units;
•
At least one Channel Board;
•
Power Supply cable to connect the system to the mains.
7.1.1
Installing the primary power supply and the power supply units
Both the Primary Power Supply and the Power Supply Units must be inserted into the
Power Supply section located in the front lower 4U-high part of the mainframe (refer to
Section 3.3, p.22 for a description of the Power Supply section).
The Power Supply section has four housings equipped with special guides on which the
Power Supply Units can slide until they are plugged into the relevant power supply
backplane connector.
Any configuration of the SY1527 system includes at least the Primary Power Supply
(Model A1531) and one Power Supply Unit (Model A1532).
Usually the system is not delivered to the Customer with the power supplies already
inserted into their relevant housings and with the housings left covered with appropriate
panels. In order to install the Power Supply Units, please refer to the two following
procedures.
To install the Primary Power Supply:
1)
Turn the system off by the main switch located on the rear panel (refer to Fig.
3.6, p.35), disconnect the system from the mains and wait for at least 1 minute;
2)
Remove the cover panel, if any, from the rightmost housing by loosening the
four single-slot screws following a criss-cross pattern;
3)
Take the Primary Power Supply (Model A1531) by its handle, sliding it on the
guides into the rightmost housing (Housing 0) until it is plugged into the relevant
backplane connector;
4)
Tighten the four single-slot screws on the front panel of the Primary Power
Supply following a criss-cross pattern.
