16
2.2 REPLACEMENT OF THE FUSE
To replace the fuse:
•
Press on the cover of the fuse holder and rotate it about 20° counterclockwise.
•
Remove the cover of the fuse holder.
•
Remove the fuse from the cover of the fuse holder.
•
Replace the fuse with one with an identical one.
•
Reposition the cover of the fuse holder.
•
Press the cover and rotate it about 20° clockwise.
2.3 RESET THE SAFETY THERMOSTAT
•
This oven is equipped with a manually resettable safety thermostat designed
to protect the oven against overheating. If there is an intervention, it
completely deactivates the oven to avoid permanent damage.
•
To reset this device, remove the black cap positioned to the bottom of the
back of the oven by unscrewing it counterclockwise, push the reset button
under the cap, and replace the black cap.
•
If the safety thermostat shuts your oven off, before turning your oven back on,
be sure to check your entire circuit to verify that the total amps being drawn by all the appliances, lights,
etc. on that circuit do not exceed the amps available on that circuit.
2.4 TROUBLESHOOTING
Problem
Possible Cause
Possible Solution
Problem Solution
Oven is completely
switched off
- No power
- Safety thermostat has
intervened to avoid
overheating
- Oven is out of order
- Check that unit is
plugged into correct
outlet type
- Reset the safety
thermostat (see 2.3 above)
- Contact Cadco Service
Contact Cadco Service
No humidity is produced
in the oven cavity
(Dynamic models only)
- Water inlet is closed
- Oven is connected to
the water supply or
water tank incorrectly
- Water tank is empty
- Water supply filter is
clogged
- Open water inlet
- Make sure oven is
connected to water supply/
tank correctly
- Fill the tank with water
- Clean the filter
Contact Cadco Service
After the time has been set
and START/STOP button
has been pressed, the oven
does not start
Door is open or has not
been shut correctly
Make sure the door is
completely shut
Contact Cadco Service
Water escapes from the
door gasket when the door
is shut.
- Gasket is dirty
- Gasket is damaged
- Door handle mechanism
is loose
- Clean the gasket with a
damp cloth
- Replace gasket
- Get handle mechanism
repaired or replaced
Contact Cadco Service
