General Configuration Screen
DLEHF-MA User’s Guide
5-49
5.15.10 Setting the Management Mode
To set the Management Mode, proceed as follows:
1.
Use arrow keys to highlight the Management Mode field.
2.
Press the SPACE bar to step to the appropriate management mode,
(DISTRIBUTED or STAND ALONE).
3.
Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER. The warning screen shown back in
Figure 5 displays.
4.
Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
5.15.11 Configuring the COM Port
Upon power up, the COM port is configured to the default settings of
ENABLED and LM.
Upon saving the new operational mode, the module will reboot.
If the DLEHF-MA has been set to 802.1Q SWITCHING, refer to
the
Port Based VLAN User’s Guide to configure the device for
this type of operation.
Upon saving the new operational mode, the module will reboot.
If the module will be set to STAND ALONE, ensure the
following procedures have been completed:
The module has been assigned a unique IP address that has
been saved (i.e., the module has rebooted and the new IP
address is active).
The module has been assigned SNMP community names from
the module SNMP Community Names screen. In STAND
ALONE management mode, the module does not use the
community names of the DLM6C-AA chassis.
!
Before altering the COM port settings, ensure that a valid IP
address is set for the module or chassis. (Refer to
Section 5.15.1.) Read this entire COM port configuration
section before changing the settings of the COM port.
