![background image](http://html.mh-extra.com/html/cab/a4/a4_service-manual_479016063.webp)
63
Serviceanleitung / Service Manual
/
/
/
6.
Pull out the following connectors from the PCB (8)
- connector (7) of the Power Input Module
- Power Cable (9)
- printhead power connector (10).
7.
Remove the two screws M4x10 (6) from the cooling
plate and remove the power supply (8).
8.
To fit the new power supply follow the above steps in
the reverse order.
6.
Ziehen Sie folgende Stecker von der Leiterplatte (8)
- Netzeingang (7)
- Leitung Netzteil (9)
- Druckkopf-Leistungsanschluss (10).
7.
Entfernen Sie zwei Schrauben M4x10 (6) aus dem
Kühlblech und entnehmen Sie das Netzteil (8).
8.
Bauen Sie das neue Netzteil in umgekehrter Reihen-
folge wieder ein.
Bild 46
Wechseln des Netzteils II
Fig. 46
Replacing the Power Supply II
7
9
8
10
6
6