BYD S1 EV, User Manual

Page: 237 / 254

7
In
case
of a
fault
7-1 In case of a fault 237
Tip
●
Tighten the nuts with a wheel nut wrench. Do not use other tools or any lever other
than your hand, such as a hammer, tube or foot.
●
Ensure the wrench is tightly installed on the nut.
■
Tighten the nuts in the order shown
step by step until all nuts are
tightened fully.
Note
●
When the car is lowered onto the ground, ensure that all parts of the body and all
surrounding persons cannot be injured.
●
After replacing the spare wheel, the wheel nuts must be tightened to the tightening
torque of 120 N•m. Otherwise, the nuts will be loosened, resulting in its falling off
and even a serious accident.
After wheel replacement
9. Check the tire pressure after replacement.
■
Adjust the tire pressure to the specified value. If the tire pressure is lower than the
specified value, slowly drive the car to a nearby service station to inflate the tire to the
correct pressure value.
■
Must install the tire air valve cap; otherwise it may cause the air leakage because the
dust and moisture enter the air valve core. If the air valve cap is lost, must install a new
one as soon as possible.
10. Collect all tools, jack, and deflated tire in place.
■
After replacing the wheel, must tighten the wheel nuts to the specified tightening
torque with a torque wrench.
■
The deflated tire must be repaired by a technician.