BYD EPS14P, Operator'S Manual

Page: 24 / 38

MAINTENANCE
OPERATOR MANUAL 46
EPS14P
47 OM-EPS14P2019001-EN
Caster Wheel Replacement
(1) Use the floor jack to raise the forklift, and then place the hardwood block under it. Loosen
the bolt to take out the wheel assembly.
(2) Loosen the nut and bolt to replace the wheel.
CODE PART NAME QTY CODE PART NAME QTY
15 BOLT M16
×
160 1 20 CASTOR WHEEL 2
16 NUT M16 1 110 N-m 21 BOLT M12
×
45 1 90 N-m
17 BUSHING 1 22 SPRING WASHER 1
18 SPRING WASHER M16 1 23 WASHER 3
19 WASHER M12 1
Caution
After replacement, the truck balance should be adjusted.
Driving Wheel Replacement
Use the floor jack to raise the forklift, and then place the hardwood block under it. Loosen the
nuts to replace the wheel.
。
CODE PART NAME QTY
11 NUT 5 90 N-m
12 SPRING WASHER 5
Caution
After replacement, the truck balance should be adjusted.
Gear Oil Level Checking
(1) Clean the surrounding areas around the oil filler plug, and then unscrew it with the seal.
(2) Check the oil level. The correct oil level and the correct oil quantity is achieved when the
oil level is at the lower edge of the oil filler plug. Add gear oil if necessary.
(3) After checking, screw in the oil filler plug with the sealing ring.
11
12
CODE PART NAME QTY
11
OIL FILLER PLUG
1 30 N-m
12 SEALING RING 1
Caution
(1) While adding oil, be careful to prevent dust and water from entering the oil tank.
(2) The oil level should be just at the lower edge of the oil filler hole.
12
11
15
16
17
18
20
20
23
23
23
19
22
21